RangeHoodeRepair.center (844) 398-3217Mon–Sat, 8am–8pm Book a visit
A technician's hands sliding a clean baffle filter back into the underside of a range hood.

What we do

Range hood
repair,
job by job.

Ten repairs we take on. Every range hood repair we offer has its own page: the part the technician actually replaces, how the job compares with its neighbors on the list, and when an aging hood is no longer worth the part.

(844) 398-3217

Mon–Sat, 8am–8pm

  • 10 repairs
  • 9 priced jobs
  • Workmanship warranty

Book a visit

Three short steps, about a minute.

or call (844) 398-3217

Familiar brands. Expert care.

For the brands
in your kitchen.

Independent repair service. Not affiliated with, authorized or endorsed by any manufacturer. Brand names and model numbers are the property of their respective owners and are used here for identification only, to describe the appliances we service.

All 29 brands

The work itself

In the order it gets done: the cheapest cause first, and the expensive answer at the bottom where it usually belongs.

A technician in a plain gray work shirt stands on the kitchen floor beside a stainless wall-mount range hood in a US home, holding a small handheld airflow vane meter up under the range hood's filters, the range hood lamps lit, steam rising from a pot on the burners below, the cooking surface cropped and out of focus. Diagnostic fee

Range hood diagnostic visit

A visit that runs the hood through every speed and light, tests the draw at the filters and follows the air outside until one part is named.

 A new range hood blower assembly, a black motor with a clean squirrel-cage wheel, resting on a folded drop cloth on a kitchen counter in a US home, a stainless range hood above it with its filters removed and its lamps lit, the range hood's open underside out of focus in the background. Cost: moderate to highest

Range hood blower motor repair

Testing and renewing the fan that moves a hood's air, in the canopy, the duct or on the roof: its capacitor, bearings, wheel or the motor itself.

 A close view of the front edge of a stainless under-cabinet range hood in a US home kitchen, its row of push keys set in the range hood's lip, a technician's clean fingertip pressing one blank key, the lamps beside it glowing, the cooking surface below soft and out of focus. Cost: low to moderate

Range hood fan switch and control repair

Repairing the part the cook touches: rocker switches, push keys or a glass touch strip, and the harness that carries their signal to the blower.

 A new green electronic control board for a range hood lying in an open plain brown parts box on a kitchen counter in a US home, a stainless range hood insert with its baffle filters removed out of focus above it, soft daylight. Cost: moderate

Range hood control board repair

Testing and replacing the board behind a keypad or touch strip: the relays for each speed and the lights, the timers and the power supply.

 Looking up at the underside of a stainless wall-mount range hood in a US home kitchen, one round lens cover removed and set aside and a new small LED lamp module fitted in its socket, the range hood's other lamps glowing warmly, stainless baffle filters between them, soft steam in the air below. Cost: low

Range hood light repair

Bringing back the lamps over the burners: halogen and LED lamps, their sockets and covers, and the transformer or driver that powers them.

 A set of clean stainless baffle filters drying on a folded towel on a kitchen counter in a US home, a stainless range hood above with its filter openings empty and its lamps lit, the range hood filling the upper half of the frame, a technician's hands in gray sleeves sliding the last baffle filter back into the range hood. Cost: lowest

Range hood filter and baffle service

Cleaning or replacing what catches grease and odor: mesh and baffle filters, charcoal pads on recirculating hoods, and the grease channel.

 Looking up into the open underside of a stainless range hood in a US home kitchen with its filters removed, the round backdraft damper at the top of the range hood's blower outlet visible with its two metal flaps half open, a gloved hand holding a new damper beside it, soft light. Cost: low to moderate

Range hood damper and duct repair

Getting the air out of the house: the backdraft damper, the duct and its joints, the wall or roof cap, and make-up air in a tight house.

 A technician in a plain gray work shirt standing on the floor of a US home kitchen with one hand resting flat against the canopy of a stainless island range hood, head tilted listening, the range hood running with its lamps on, the range hood filling the upper half of the frame, the island burners cold and out of focus below. Cost: low to moderate

Range hood noise and vibration repair

Finding what makes a hood roar, rattle or shake, from a grease-heavy wheel or loose screws to a flapping damper, and quieting it at the source.

 A stainless pop-up downdraft vent risen from the stone counter behind the burners on a kitchen island in a US home, steam from a pot drawn sideways into the downdraft vent's slotted intake, the downdraft vent sharp and centered, the pot and burners soft in the foreground. Cost: moderate

Downdraft vent lift repair

Repairing the pop-up vent that rises behind the burners: its lift motor and gears, the limit switches, the blower below and its controls.

 Looking up at the underside of a stainless range hood in a US home kitchen with one baffle filter removed, a small round silver heat sensor disc visible on the range hood's inner panel, its two wires neatly connected, the range hood's lamps glowing and soft steam in the foreground. Cost: low

Range hood heat sensor repair

Testing the sensor that starts the fan by itself when the burners get hot, so the hood starts when it should and stops when the heat is gone.

 Before you book

What each of these usually costs

Bands rather than prices, because nobody can quote a figure before the range hood has been looked at — and the diagnostic visit that decides it, set against the repair.

10 repairsCheapest firstDiagnostic visit Read the cost guide

What a repair
usually costs.

Set the repair against what a new range hood would really take to put up, not just its price on a shelf. A chimney hood needs its brackets, duct collar and tile cut to line up again; an island model comes down from the ceiling frame with two people; an insert has to fit the opening a cabinetmaker built around it. Filters, lamps, switches, dampers, capacitors and heat sensors are small next to that, and even a blower or a board is usually the better choice on those three. A basic recirculating under-cabinet hood is the exception: it is quick to swap, so on an older one with a failed motor the technician shows you both numbers side by side.

Range hood diagnostic visit: A range hood is priced once its fan, its controls and its air path have been tested.
Read the full cost guide
RepairRelative costNotes
Blower motor, run capacitor, bearings or blower wheel moderate to highest A capacitor or a degreased wheel sits near the bottom of this band. A complete motor, a twin-blower assembly or a fan that lives in the attic or on the roof climbs to the top, with the reach adding labor of its own.
Rocker or slide switch, key panel, touch strip or wall keypad low to moderate A mechanical switch block on a basic hood is a small part. A glass touch strip, a membrane panel for a pro-style canopy or a remote keypad with its cable run through the cabinet moves one step up.
Control board with its relays and power supply moderate The board is the dearest electronic part in most hoods, and one for an imported or premium liner can take time to arrive. Clearing the grease or heat that cooked the old one is part of the same job.
Lamps, sockets, lens covers or the LED driver low Lamps and lenses are inexpensive. A scorched socket set, a low-voltage transformer or an LED driver hidden above the filters costs more, mostly in the time it takes to reach and test them.
Mesh or baffle filters, charcoal pads and the grease channel lowest Cleaning and refitting the filters with a new set of charcoal pads is the smallest job on this page. Replacement baffles for a wide pro-style canopy, or grease that has already reached the hood body, add to it.
Backdraft damper, duct joints or the outside cap flap low to moderate Freeing or replacing a damper at the top of the canopy is a small part and a short visit. Resealing joints above a ceiling, replacing a jammed wall or roof cap, or rerouting a choked run is quoted on its own once it has been seen.
Rattles, hum and vibration: wheel balance, mounts, gaskets and screws low to moderate Tightening loose panels, reseating filters and adding gaskets costs little beyond the visit. A new motor mount, a replacement wheel or bearings moves it up, and a mounting that has worked loose from the wall or ceiling is priced on sight.
Downdraft lift motor, drive gears, limit switches or its blower moderate A limit switch or a cleaned track is modest. A lift motor, a drive screw assembly or the blower under the counter costs more, and the cabinet below has to be emptied to reach them.
Heat sensor or thermostat disc and its lead low The sensor is a small part fitted from the underside of the canopy. When the board that reads it has also failed, the job joins the control board row instead.

Start from what you noticed

Most people arrive knowing the symptom, not the repair. These are the jobs each one usually turns out to be, cheapest first — and every one of them starts with the range hood diagnostic visit.

All 17 problems
A family cooking together under a stainless range hood in a bright kitchen.
For the heart of your home.

Questions about
the work.

I only know the smoke hangs in the kitchen. Which range hood service fits?
Choose the diagnostic visit and describe what the fan, the lights, the filters or the damper are doing. Tying that to one of the repairs listed below is the technician's work, and nothing is ordered or priced before it is done.
My range hood has two separate problems. Will one visit cover both?
Most of the time, and on a hood one failure often leads to the next: a filter packed with grease makes the blower strain until its capacitor gives out, and a damper stuck half shut makes the fan roar and pull poorly at once. Each repair gets its own price, and you decide which, if any, to go ahead with.
Where can I see what these range hood repairs cost?
A light driver on an under-cabinet hood and the same part on an island hood hung from a vaulted ceiling are one part and two very different amounts of labor. The cost page sorts range hood jobs into bands, and the diagnosis tells you which band yours belongs in.
Does the technician bring range hood parts, or come back later?
Run capacitors, speed switches, bulbs, LED modules, light drivers and damper flaps are usually in the van, and a model number in the booking improves the odds further. A part built for one model, such as a blower assembly, a control board, a keypad or a remote blower, is ordered after the diagnosis and fitted on a second trip once it arrives.

Back to your everyday

Let’s get your range hood working again.

Three short steps online, or one call. Tell us what you are seeing and pick a window that works.

Schedule a repair Call (844) 398-3217
(844) 398-3217 Schedule a repair