RangeHoodeRepair.center (844) 398-3217Mon–Sat, 8am–8pm Book a visit
A stainless steel wall-mount chimney range hood fixed to a white subway tile wall in a US home kitchen, the range hood's rectangular chimney cover rising straight to the ceiling, soft steam rising from a pot into the canopy, the range hood filling the upper half of the frame, the cooking surface below cropped and out of focus at the bottom edge.

Faber
Range Hood Repair

A Faber range hood that runs on only one speed, or hums without spinning, gets a visit that starts at its speed control.

(844) 398-3217

Mon–Sat, 8am–8pm

  • 4 range hood types
  • 6 problems we see
  • 5 error codes

Book a visit

Three short steps, about a minute.

or call (844) 398-3217

Faber range hoods,
specifically.

Faber, founded in Fabriano, Italy in 1955 and part of the Franke Group, sells wall, island and ceiling, insert, pro and under-cabinet, integrated and downdraft hoods in the US through faberonline.com. Its US hoods come with airflow options (295, 395 or 600 CFM) and button controls that count filter hours, so a repair call often begins with how the hood was set up. We then test the blower, its speeds and the lighting.

The Faber lineup

Builds4 range hood types

Wall-mount range hood · Under-cabinet range hood · Island range hood · Range hood insert

Called out forRange Hood Fan Stuck on One Speed

and 5 more problems on Faber

Repairs we do10 repairs, on any make

Range hood diagnostic visit · Range hood blower motor repair · Range hood fan switch and control repair · Range hood control board repair

Error codesFilter alarm LED on (steady) · Filter alarm LED flashing · Intensive speed drops back after 6 or 10 minutes · Top speeds disabled after CFM adjustment · All LEDs flash two or three times

5 Faber codes with a page of their own

The Faber
lineup.

Faber builds 4 of the 4 range hood types this site covers. Which one decides how the visit is planned.

All range hood types
Wall-mount

Wall-mount range hood

3 of the problems we see on Faber come up on it Wall-mount range hood repair Under-cabinet

Under-cabinet range hood

4 of the problems we see on Faber come up on it Under-cabinet range hood repair Island

Island range hood

2 of the problems we see on Faber come up on it Island range hood repair Insert or liner

Range hood insert

3 of the problems we see on Faber come up on it Range hood insert repair

What is particular
to Faber.

We repair Faber wall hoods such as Stilo and Dama, island and ceiling hoods like Highlight and Stratus Isola, Inca inserts, Breva and Camino pro and under-cabinet hoods, and integrated and downdraft models. The installation guide for each model is posted on its faberonline.com product page.

Airflow limits that stick

Faber installers can cap a hood below 295 or 395 CFM, and the guides say that cannot be undone. On a capped hood the top speed or intensive button stops working, which owners sometimes mistake for a dead keypad.

Hour-counted filter alarms

Faber counts 100 working hours before asking for clean grease filters and 200 before asking for charcoal. A steady light and a flashing light on the same button mean different filters.

Intensive is a timed burst

The top intensive speed runs 6 or 10 minutes depending on the model and then drops back. A hood that seems to slow down by itself is usually just finishing that timer.

Franke stands behind it

In the US, Faber-branded hoods are covered by Franke, and the guide gives two years on labor and replacement parts for standard residential use. We note the purchase date on the first visit so you know where you stand.

Parts

Faber publishes a separate parts document for many models alongside the guide, which helps match boards, blowers and lamps by part number. Charcoal and grease filters are the most frequent orders.

Repair or replace

A Faber with a failed keypad, lamp or blower is normally worth repairing, especially an insert built into cabinetry. If a limited-airflow hood is too weak for the burners, the fix is a different hood or duct, not a repair.

Book your Faber visit

What we are
called out for.

On Faber, most often range hood fan stuck on one speed.

All problems

Faber error codes

All Faber codes
Close view of the side panel of a stainless island range hood with a row of four round push buttons for fan speed, one lit and the rest dark, the range hood's canopy filling the upper half of the frame above a kitchen island.

Range Hood Fan Stuck on One Speed

6 causes, cheapest first

 A stainless wall-mount chimney range hood on a tiled wall fills the upper half of the frame, a haze of cooking steam spilling past the front and side edges of the range hood's canopy and hanging in the kitchen air, a mesh grease filter under the canopy visibly dark with grease.

Range Hood Runs but Barely Pulls Smoke

7 causes, cheapest first

 Close view of the front edge of a stainless wall-mount range hood with a slim glass touch control strip, a few abstract lit dots on it and a faint film of steam on the glass, the range hood's canopy filling the upper half of the frame.

Range Hood Buttons or Keypad Not Responding

6 causes, cheapest first

 Close view looking up at the underside of a stainless under-cabinet range hood below white cabinets, two recessed lights in the range hood's underside, one glowing warm and the other dark with a slightly browned lens, the mesh filters between them clean.

Range Hood Lights Out or Flickering

6 causes, cheapest first

Not a
Faber?

Faber is one of 29 range hood makes on this site. The other 28 each have a page of their own.

All 29 brands

Faber range hood repair,
where we come out.

9 metros, each with its own page.

All service areas

Tampa BayFL · 31 areas

OrlandoFL · 30 areas

Miami / South FloridaFL · 47 areas

New York MetroNY · 75 areas

HoustonTX · 36 areas

ChicagoIL · 50 areas

Los AngelesCA · 95 areas

San DiegoCA · 31 areas

San Francisco Bay AreaCA · 74 areas

A family cooking together under a stainless range hood in a bright kitchen.
For the heart of your home.

Questions about
Faber range hoods.

Why does my Faber hood's highest button not work?
If the hood was set below 295 or 395 CFM at installation, the top speed or intensive button is disabled for good. Look for the CFM label behind the grease filters.
Who covers a Faber hood's warranty in the US?
Franke covers Faber-branded products in the United States; the guide lists two years for labor and replacement parts in standard residential use.
How long does delay-off run on a Faber?
It depends on the model: 15 minutes on the Stilo and Dama wall hoods, 30 minutes on the Highlight.
Is Faber an Italian brand?
Yes. Faber was founded in Fabriano, Italy, and has been part of the Franke Group since 2005.

Back to your everyday

Book your Faber visit.

Have the range hood's model number ready — on Faber it decides which parts come on the first visit.

Schedule a repair Call (844) 398-3217
(844) 398-3217 Schedule a repair