KitchenAid hood fan icon flashing with 10:00 on the display
Holding the Timer button for 5 seconds starts Timed Fan Off.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: KitchenAid
Book a visit
Three short steps, about a minute.
or call (844) 398-3217
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Fan icon flashing with 10:00
actually means.
Holding the Timer button for 5 seconds starts Timed Fan Off. The fan icon flashes, 10:00 appears, and after 3 seconds the count begins; when it reaches zero the blower switches itself off. It lets the fan clear the last of the cooking air without being left on.
KitchenAid range hood display · also shown as Timed Fan Off
What to do when Fan icon flashing with 10:00 shows on the range hoodKind of codeMode, not a failure
The hood is doing something it was told to do, not wearing out: a delay-off timer that keeps the blower running for some minutes after the burners go off, a heat sentry that starts the fan by itself when it senses a hot pan, a Sabbath setting that locks the keys and dims the lights, or a link to the cooking surface that sets the speed on its own. No part is needed; a key sequence from the manual, or simply waiting, ends it.
Usually leads toNo repair
Let the countdown run if you want the fan to switch itself off.
Shows up asReading a Range Hood Error Code or Blinking Light
A range hood error code may appear as letters and numbers on a display, a light that blinks in a pattern, a filter reminder that will not clear, or a beep with the fan refusing to start.
MakeKitchenAid
KitchenAid range hoods with a fan that stalls, lamps that stay dark or buttons that do nothing are checked in the kitchen they serve.
SourceKitchenAid 30" and 36" range hood installation instructions and use and care guide W10674120
KitchenAid 30- and 36-inch under-cabinet hood, guide W10674120.
Before you book,
in this order.
Each step comes from KitchenAid's own guidance for Fan icon flashing with 10:00 on its range hoods. Follow it to the end: the last card says whether this is a visit.
Let the countdown run if you want the fan to switch itself off.
To keep the fan on, cancel the timer with the Timer button.
If the blower keeps running after the count ends, or stops long before it, book a visit.
Cleared?
The code is gone and the blower pulls steam up on every speed again without a new part. If it returns this week, or the filter reminder keeps coming back right after a cleaning, mention it in the booking.
What not to do
The flashing icon is not a blower warning. The separate kitchen timer, set from 1 to 60 minutes, only counts time and does not switch the fan off.
What you may
notice with it.
The range hood problems Fan icon flashing with 10:00 tends to arrive with. Answer these at the range hood before anyone is booked.
All problems
No repair indicated
Nothing to repair.
The hood is doing something it was told to do, not wearing out: a delay-off timer that keeps the blower running for some minutes after the burners go off, a heat sentry that starts the fan by itself when it senses a hot pan, a Sabbath setting that locks the keys and dims the lights, or a link to the cooking surface that sets the speed on its own. No part is needed; a key sequence from the manual, or simply waiting, ends it.
KitchenAid
range hoods.
KitchenAid range hoods with a fan that stalls, lamps that stay dark or buttons that do nothing are checked in the kitchen they serve.
KitchenAid range hood repairMore KitchenAid codes
Mode, not a failure on other makes
Wall-mount range hood
The chimney hood fixed to a bare stretch of wall above the burners, its canopy catching the rising smoke while a telescoping cover hides the duct that climbs to the ceiling.
Under-cabinet range hood
The slim hood screwed to the bottom of the wall cabinet over the burners, venting up through that cabinet or back through the wall, or cleaning the air and returning it to the room.
Island range hood
The hood that hangs from the ceiling over burners set into a kitchen island, open on all four sides, with its duct and wiring hidden inside a chimney that drops from above.
In KitchenAid's own words
The fan icon will flash and 10:00 (10 minutes) will show in the display.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. KitchenAid 30- and 36-inch under-cabinet hood, guide W10674120.
KitchenAid Fan icon flashing with 10:00 range hood repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Fan icon flashing with 10:00.
Can I clear Fan icon flashing with 10:00 myself?
Why did my KitchenAid hood switch itself off after cooking?
How do I start Timed Fan Off on a KitchenAid hood?
Can I change the 10-minute run time on my KitchenAid hood?
Back to your everyday
Still showing Fan icon flashing with 10:00?
Three things make the booking useful: the letters or blink pattern exactly as they showed, the full model number from the label behind the filters, and whether the fan still moves air on every speed. With those, the technician arrives with half the answer already worked out.