Elica Snd on the display: key beeps switched on or off
Holding the Light button for 5 seconds toggles the audible signal.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Elica
Book a visit
Three short steps, about a minute.
or call (844) 398-3217
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Snd
actually means.
Holding the Light button for 5 seconds toggles the audible signal. If a tone sounds with Snd, beeps are now on; if Snd appears silently, they are off.
Elica range hood display · also shown as audible signal on or off
What to do when Snd shows on the range hoodKind of codeMode, not a failure
The hood is doing something it was told to do, not wearing out: a delay-off timer that keeps the blower running for some minutes after the burners go off, a heat sentry that starts the fan by itself when it senses a hot pan, a Sabbath setting that locks the keys and dims the lights, or a link to the cooking surface that sets the speed on its own. No part is needed; a key sequence from the manual, or simply waiting, ends it.
Usually leads toNo repair
No repair is needed.
Shows up asReading a Range Hood Error Code or Blinking Light
A range hood error code may appear as letters and numbers on a display, a light that blinks in a pattern, a filter reminder that will not clear, or a beep with the fan refusing to start.
MakeElica
Elica hoods, whether ducted outdoors or set up to recirculate, are serviced on site with the filters and controls checked first.
SourceElica Pilato (EPL630S2, EPL636S2) use, care and installation guide
Pilato EPL630S2 and EPL636S2.
Before you book,
in this order.
Each step comes from Elica's own guidance for Snd on its range hoods. Follow it to the end: the last card says whether this is a visit.
No repair is needed.
Hold Light for 5 seconds again if you want the opposite setting.
If Snd appears without anyone touching the panel, clean the control dry and book a visit if it repeats.
Cleared?
The code is gone and the blower pulls steam up on every speed again without a new part. If it returns this week, or the filter reminder keeps coming back right after a cleaning, mention it in the booking.
What not to do
Snd is not a sound system or speaker problem, and it does not mean the control is resetting. A silent keypad after Snd simply means the beeps were turned off.
What you may
notice with it.
The range hood problems Snd tends to arrive with. Answer these at the range hood before anyone is booked.
All problems
No repair indicated
Nothing to repair.
The hood is doing something it was told to do, not wearing out: a delay-off timer that keeps the blower running for some minutes after the burners go off, a heat sentry that starts the fan by itself when it senses a hot pan, a Sabbath setting that locks the keys and dims the lights, or a link to the cooking surface that sets the speed on its own. No part is needed; a key sequence from the manual, or simply waiting, ends it.
Elica
range hoods.
Elica hoods, whether ducted outdoors or set up to recirculate, are serviced on site with the filters and controls checked first.
Elica range hood repairMore Elica codes
Mode, not a failure on other makes
Wall-mount range hood
The chimney hood fixed to a bare stretch of wall above the burners, its canopy catching the rising smoke while a telescoping cover hides the duct that climbs to the ceiling.
Under-cabinet range hood
The slim hood screwed to the bottom of the wall cabinet over the burners, venting up through that cabinet or back through the wall, or cleaning the air and returning it to the room.
Island range hood
The hood that hangs from the ceiling over burners set into a kitchen island, open on all four sides, with its duct and wiring hidden inside a chimney that drops from above.
In Elica's own words
the “Snd” symbol must appear on the display for 3 seconds.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Pilato EPL630S2 and EPL636S2.
Elica Snd range hood repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Snd.
Can I clear Snd myself?
Why did my Elica stop beeping?
How do I turn the beeps back on on my Elica Pilato?
Is Snd on my Elica an error message?
Back to your everyday
Still showing Snd?
Three things make the booking useful: the letters or blink pattern exactly as they showed, the full model number from the label behind the filters, and whether the fan still moves air on every speed. With those, the technician arrives with half the answer already worked out.