Monogram professional hood: all icons lit during Chef Connect pairing
Holding the CHEF CONNECT pad for 3 seconds starts Bluetooth pairing with a compatible Monogram or GE cooking appliance.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Monogram
Book a visit
Three short steps, about a minute.
or call (844) 398-3217
Loading appointment form…
The appointment form couldn’t load. Please try again.
What All icon backlights lit, then CHEF CONNECT light solid
actually means.
Holding the CHEF CONNECT pad for 3 seconds starts Bluetooth pairing with a compatible Monogram or GE cooking appliance. The backlight for all the icons stays lit until the link is made, then the indicator above CHEF CONNECT turns on and stays solid. If nothing pairs within 2 minutes, the attempt ends.
Monogram range hood display · also shown as Chef Connect pairing
What to do when All icon backlights lit, then CHEF CONNECT light solid shows on the range hoodKind of codeMode, not a failure
The hood is doing something it was told to do, not wearing out: a delay-off timer that keeps the blower running for some minutes after the burners go off, a heat sentry that starts the fan by itself when it senses a hot pan, a Sabbath setting that locks the keys and dims the lights, or a link to the cooking surface that sets the speed on its own. No part is needed; a key sequence from the manual, or simply waiting, ends it.
Usually leads toNo repair
Start pairing on the cooking appliance below within 2 minutes.
Shows up asReading a Range Hood Error Code or Blinking Light
A range hood error code may appear as letters and numbers on a display, a light that blinks in a pattern, a filter reminder that will not clear, or a beep with the fan refusing to start.
MakeMonogram
Monogram hoods and hood inserts are repaired in place, working from the control panel back to the blower and the damper.
SourceMonogram stainless steel professional vent hoods with QuietBoost blower owner's manual 49-2000705
Monogram ZVW1360 and ZVW1480 professional hoods, owner's manual 49-2000705. On the ZVWS pyramid hoods pairing starts from the Light button and the Chef Connect indicator blinks instead.
Before you book,
in this order.
Each step comes from Monogram's own guidance for All icon backlights lit, then CHEF CONNECT light solid on its range hoods. Follow it to the end: the last card says whether this is a visit.
Start pairing on the cooking appliance below within 2 minutes.
Look for the light above CHEF CONNECT to turn solid.
To cancel, hold CHEF CONNECT for 3 seconds and then turn off the hood.
If the icons stay lit long after 2 minutes, switch the breaker off for 30 seconds; if it repeats, book a visit.
Cleared?
The code is gone and the blower pulls steam up on every speed again without a new part. If it returns this week, or the filter reminder keeps coming back right after a cleaning, mention it in the booking.
What not to do
Icons lighting up together during pairing are not a short or a failed keypad. All pads blinking on and off without end is the separate Default Settings Mode.
What you may
notice with it.
The range hood problems All icon backlights lit, then CHEF CONNECT light solid tends to arrive with. Answer these at the range hood before anyone is booked.
All problems
No repair indicated
Nothing to repair.
The hood is doing something it was told to do, not wearing out: a delay-off timer that keeps the blower running for some minutes after the burners go off, a heat sentry that starts the fan by itself when it senses a hot pan, a Sabbath setting that locks the keys and dims the lights, or a link to the cooking surface that sets the speed on its own. No part is needed; a key sequence from the manual, or simply waiting, ends it.
Monogram
range hoods.
Monogram hoods and hood inserts are repaired in place, working from the control panel back to the blower and the damper.
Monogram range hood repairMore Monogram codes
Mode, not a failure on other makes
Wall-mount range hood
The chimney hood fixed to a bare stretch of wall above the burners, its canopy catching the rising smoke while a telescoping cover hides the duct that climbs to the ceiling.
Under-cabinet range hood
The slim hood screwed to the bottom of the wall cabinet over the burners, venting up through that cabinet or back through the wall, or cleaning the air and returning it to the room.
Island range hood
The hood that hangs from the ceiling over burners set into a kitchen island, open on all four sides, with its duct and wiring hidden inside a chimney that drops from above.
In Monogram's own words
The backlight for all the icons will light up until the hood is paired with the range or other device.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Monogram ZVW1360 and ZVW1480 professional hoods, owner's manual 49-2000705. On the ZVWS pyramid hoods pairing starts from the Light button and the Chef Connect indicator blinks instead.
Monogram All icon backlights lit, then CHEF CONNECT light solid range hood repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about All icon backlights lit, then CHEF CONNECT light solid.
Can I clear All icon backlights lit, then CHEF CONNECT light solid myself?
Why are all the icons on my Monogram hood lit at once?
How do I know my Monogram hood paired?
My Monogram hood will not pair. What should I check?
Back to your everyday
Still showing All icon backlights lit, then CHEF CONNECT light solid?
Three things make the booking useful: the letters or blink pattern exactly as they showed, the full model number from the label behind the filters, and whether the fan still moves air on every speed. With those, the technician arrives with half the answer already worked out.