BEST WPP1 chimney hood with all four speed lights flashing: clean the filters
The WPP1 counts blower hours and after 25 of them flashes all four speed indicators for half a minute.
Mon–Sat, 8am–8pm
- Filter reminders
- Range hood filter and baffle service
- Source: BEST
Book a visit
Three short steps, about a minute.
or call (844) 398-3217
Loading appointment form…
The appointment form couldn’t load. Please try again.
What All 4 blower speed lights flash for 30 seconds
actually means.
The WPP1 counts blower hours and after 25 of them flashes all four speed indicators for half a minute. The manual ties it to filter cleaning so the hood keeps its airflow. Pressing the OFF blower button, which doubles as the filter maintenance button, clears the count.
BEST range hood display · also shown as filter maintenance signal, WPP1 filter reminder
What to do when All 4 blower speed lights flash for 30 seconds shows on the range hoodKind of codeFilter reminders
The hood has counted enough hours of fan time to ask for its filters: the mesh or baffle grease filters want a wash, or on a recirculating hood the charcoal filters want replacing. Most hoods count hours rather than measure grease, so the light comes on whether the filters are clean or not, and it stays on until it is reset with the key the manual names. A reminder that returns straight after a reset, or a hood that still pulls weakly with fresh filters, is worth a visit.
Usually leads toRange hood filter and baffle service
Cleaning or replacing what catches grease and odor: mesh and baffle filters, charcoal pads on recirculating hoods, and the grease channel.
Shows up asReading a Range Hood Error Code or Blinking Light
A range hood error code may appear as letters and numbers on a display, a light that blinks in a pattern, a filter reminder that will not clear, or a beep with the fan refusing to start.
MakeBEST
BEST hood inserts and chimney hoods get a visit that traces the airflow from the filters up to wherever the blower is mounted.
SourceBEST WPP1 series chimney hood installation instructions
WPP1 series pro-style chimney hoods (WPP1366SS, WPP13612SS, WPP14812SS). BEST touch-control hoods with an LED bar use a different reminder after 30 hours.
Before you book,
in this order.
Each step comes from BEST's own guidance for All 4 blower speed lights flash for 30 seconds on its range hoods. Follow it to the end: the last card says whether this is a visit.
Switch the blower off and remove the baffle filters by pushing them toward the front of the hood and tipping them down.
Wash the filters and the grease drip rail in warm soapy water or the dishwasher, and let them dry completely before refitting.
Press the OFF blower button to reset the filter count once they are back in.
If the lights keep flashing at every start, book a visit so the control board can be looked at.
Still there?
It usually turns into range hood filter and baffle service. Book with the code and the model number.
What not to do
On the WPP1 a single flashing speed light means something else: the delay-off timer or Heat Sentry. Only all four flashing together for 30 seconds is the filter signal.
What you may
notice with it.
The range hood problems All 4 blower speed lights flash for 30 seconds tends to arrive with. Answer these at the range hood before anyone is booked.
All problems
Where All 4 blower speed lights flash for 30 seconds usually leads
Range hood filter and baffle service.
BEST
range hoods.
BEST hood inserts and chimney hoods get a visit that traces the airflow from the filters up to wherever the blower is mounted.
BEST range hood repairMore BEST codes
Filter reminders on other makes
Wall-mount range hood
The chimney hood fixed to a bare stretch of wall above the burners, its canopy catching the rising smoke while a telescoping cover hides the duct that climbs to the ceiling.
Under-cabinet range hood
The slim hood screwed to the bottom of the wall cabinet over the burners, venting up through that cabinet or back through the wall, or cleaning the air and returning it to the room.
Range hood insert
The working core of a custom hood: a steel liner or power pack carrying the blower, filters, lights and controls, fitted inside a hood built of wood, plaster or metal by a cabinetmaker.
In BEST's own words
After 25 hours of operation, the 4 blower speed lights will flash 30 seconds to indicate the filters need to be cleaned
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. WPP1 series pro-style chimney hoods (WPP1366SS, WPP13612SS, WPP14812SS). BEST touch-control hoods with an LED bar use a different reminder after 30 hours.
BEST All 4 blower speed lights flash for 30 seconds range hood repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about All 4 blower speed lights flash for 30 seconds.
Can I clear All 4 blower speed lights flash for 30 seconds myself?
How often does the BEST WPP1 ask for filter cleaning?
Which button resets the filter lights on a BEST WPP1?
Do I need to replace the WPP1 filters when the lights flash?
Back to your everyday
Still showing All 4 blower speed lights flash for 30 seconds?
Three things make the booking useful: the letters or blink pattern exactly as they showed, the full model number from the label behind the filters, and whether the fan still moves air on every speed. With those, the technician arrives with half the answer already worked out.