Falmec red light on while the fan is off: time to clean the grease filters
Falmec's electronic keypads count operating time and light the red LED steadily after roughly 30 hours to ask for anti-grease filter maintenance.
Mon–Sat, 8am–8pm
- Filter reminders
- Range hood filter and baffle service
- Source: Falmec
Book a visit
Three short steps, about a minute.
or call (844) 398-3217
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Red LED steady on with the fan off
actually means.
Falmec's electronic keypads count operating time and light the red LED steadily after roughly 30 hours to ask for anti-grease filter maintenance. It shows with the motor off so it does not get confused with the speed lights. Holding the key named in the manual for 3 seconds resets the count.
Falmec range hood display · also shown as FILTER ALARM
What to do when Red LED steady on with the fan off shows on the range hoodKind of codeFilter reminders
The hood has counted enough hours of fan time to ask for its filters: the mesh or baffle grease filters want a wash, or on a recirculating hood the charcoal filters want replacing. Most hoods count hours rather than measure grease, so the light comes on whether the filters are clean or not, and it stays on until it is reset with the key the manual names. A reminder that returns straight after a reset, or a hood that still pulls weakly with fresh filters, is worth a visit.
Usually leads toRange hood filter and baffle service
Cleaning or replacing what catches grease and odor: mesh and baffle filters, charcoal pads on recirculating hoods, and the grease channel.
Shows up asReading a Range Hood Error Code or Blinking Light
A range hood error code may appear as letters and numbers on a display, a light that blinks in a pattern, a filter reminder that will not clear, or a beep with the fan refusing to start.
MakeFalmec
Falmec hoods are inspected where they hang, including the brackets and fasteners that carry their weight.
SourceFalmec Eros under-cabinet hood instructions booklet (USA)
Eros under-cabinet and Vulcano Plus NRS wall hoods; the Massimo Pro NRS, Lumen and Stella booklets do not list this alarm.
Before you book,
in this order.
Each step comes from Falmec's own guidance for Red LED steady on with the fan off on its range hoods. Follow it to the end: the last card says whether this is a visit.
Take out the metal anti-grease filters with the hood off and soak them in hot water with a cleaning solution, or put them in the dishwasher.
Let them dry fully and refit them.
Hold the reset key for 3 seconds to turn the red light off.
If the red light stays on after a proper reset, book a visit.
Still there?
It usually turns into range hood filter and baffle service. Book with the code and the model number.
What not to do
A red light that flashes, rather than staying on, is the 15-minute timer. The alarm is not about the lamps or the blower.
What you may
notice with it.
The range hood problems Red LED steady on with the fan off tends to arrive with. Answer these at the range hood before anyone is booked.
All problems
Where Red LED steady on with the fan off usually leads
Range hood filter and baffle service.
Falmec
range hoods.
Falmec hoods are inspected where they hang, including the brackets and fasteners that carry their weight.
Falmec range hood repairMore Falmec codes
Filter reminders on other makes
Wall-mount range hood
The chimney hood fixed to a bare stretch of wall above the burners, its canopy catching the rising smoke while a telescoping cover hides the duct that climbs to the ceiling.
Under-cabinet range hood
The slim hood screwed to the bottom of the wall cabinet over the burners, venting up through that cabinet or back through the wall, or cleaning the air and returning it to the room.
Island range hood
The hood that hangs from the ceiling over burners set into a kitchen island, open on all four sides, with its duct and wiring hidden inside a chimney that drops from above.
In Falmec's own words
FILTER ALARM (red LED steady on with ( ) off )
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Eros under-cabinet and Vulcano Plus NRS wall hoods; the Massimo Pro NRS, Lumen and Stella booklets do not list this alarm.
Falmec Red LED steady on with the fan off range hood repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Red LED steady on with the fan off.
Can I clear Red LED steady on with the fan off myself?
Why is there a red light on my Falmec hood when it is off?
How often should Falmec grease filters be cleaned?
Does Falmec's red filter light mean I need new filters?
Back to your everyday
Still showing Red LED steady on with the fan off?
Three things make the booking useful: the letters or blink pattern exactly as they showed, the full model number from the label behind the filters, and whether the fan still moves air on every speed. With those, the technician arrives with half the answer already worked out.