The control strip on the front edge of a stainless chimney range hood, one small timer symbol lit beside the fan keys, steam fading above the burners below.

Gaggenau run-on key and fan level blinking in turn: interval ventilation is on

Interval ventilation runs the fan on its own for a few minutes every hour to keep air moving in the kitchen: five minutes on the AF 210 visor hood, six on the AL 400.

(844) 398-3217

Mon–Sat, 8am–8pm

  • Mode, not a failure
  • No repair needed
  • Source: Gaggenau

Book a visit

Three short steps, about a minute.

or call (844) 398-3217

What Run-on key and fan level flash alternately
actually means.

Interval ventilation runs the fan on its own for a few minutes every hour to keep air moving in the kitchen: five minutes on the AF 210 visor hood, six on the AL 400. Gaggenau shows it with the run-on key and the chosen fan level alternating. It continues until you switch the hood off.

Gaggenau range hood display · also shown as Interval ventilation on

What to do when Run-on key and fan level flash alternately shows on the range hood

Before you book,
in this order.

Each step comes from Gaggenau's own guidance for Run-on key and fan level flash alternately on its range hoods. Follow it to the end: the last card says whether this is a visit.

01

If you meant to set it, nothing is needed; the fan will cycle hourly.

02

To end it, press the fan on/off key.

03

If the fan keeps cycling after it has been switched off, book a visit.

Cleared?

The code is gone and the blower pulls steam up on every speed again without a new part. If it returns this week, or the filter reminder keeps coming back right after a cleaning, mention it in the booking.

What not to do

The alternating lights are not a warning and not a stuck key. A single steady run-on light means the ordinary run-on function, which stops by itself after a set time.

What you may
notice with it.

The range hood problems Run-on key and fan level flash alternately tends to arrive with. Answer these at the range hood before anyone is booked.

All problems

No repair indicated

Nothing to repair.

The hood is doing something it was told to do, not wearing out: a delay-off timer that keeps the blower running for some minutes after the burners go off, a heat sentry that starts the fan by itself when it senses a hot pan, a Sabbath setting that locks the keys and dims the lights, or a link to the cooking surface that sets the speed on its own. No part is needed; a key sequence from the manual, or simply waiting, ends it.

In Gaggenau's own words

For interval ventilation, the device is switched on automatically for five minutes per hour.
Gaggenau AF 2.. visor hood Use and care manual and installation instructions Gaggenau AF 2.. visor hood Use and care manual and installation instructions Gaggenau AL 400 722/792 backsplash ventilation Use and care manual

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. 200 series visor hood AF 210 (five minutes per hour) and 400 series retractable downdraft AL 400 722/792 (six minutes per hour).

Gaggenau Run-on key and fan level flash alternately range hood repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family cooking together under a stainless range hood in a bright kitchen.
For the heart of your home.

Questions
about Run-on key and fan level flash alternately.

Can I clear Run-on key and fan level flash alternately myself?
If you meant to set it, nothing is needed; the fan will cycle hourly.
Why does my Gaggenau hood start by itself every hour?
Interval ventilation is on. Look for the run-on key and a fan-level key blinking in turn, and switch the hood off to end it.
How do I turn on interval ventilation on a Gaggenau visor hood?
Switch the hood on, then press the run-on key twice. It works at fan levels 1, 2 or 3.
Does the Gaggenau downdraft need to be up for interval ventilation?
Yes. The AL 400 only runs when it is fully extended, so it stays raised while the mode is active.

Back to your everyday

Still showing Run-on key and fan level flash alternately?

Three things make the booking useful: the letters or blink pattern exactly as they showed, the full model number from the label behind the filters, and whether the fan still moves air on every speed. With those, the technician arrives with half the answer already worked out.

(844) 398-3217 Schedule a repair